Porto, Portugal
+351 960 245 977
fbnsantos@fbnsantos.com

Category: cornell

Robotics | IoT

New 5-Axis 3D Printer Creates Simple Wire Frame Models in Real Time

Watch this 5-axis 3D printer in action! Right now it only prints simple wireframes, but imagine the possibilities.
Read more on MAKE
The post New 5-Axis 3D Printer Creates Simple Wire Frame Models in Real Time appeared first on Make: DIY Projects …

Here Are the 5 Finalists for the Pitch Your Prototype Challenge

The winning project will be announced at MakerCon New York during the week of September 21. Here’s a breakdown of the five finalists.
Read more on MAKE
The post Here Are the 5 Finalists for the Pitch Your Prototype Challenge appeared first on Make…

It’s The Last Week To Vote For Your Favorite Prototype

This is the last week to vote for your favorite entry to the Pitch Your Prototype challenge, a collaboration between Make: and Cornell University with the goal of digging up the most promising prototypes from the Maker community. Visit this page to vi…

Cast Your Vote in the Pitch Your Prototype Challenge

The Pitch Your Prototype challenge is now closed to new entries, but it’s not too late to vote for your favorite submission. Online voting will run until May 18, and the winning individual or team will be announced at MakerCon New York on Septemb…

This Prototype Uses a RepRap To Play Air Hockey

With just a week left in the Pitch Your Prototype challenge, Jose Julio’s entry is more lighthearted than some of the more practical or conceptual submissions so far — though it’s still technologically impressive. Julio’s daughter …

How Hard Can You Punch the PunchBot?

One question had always bothered Russell Munro. “I have been practicing various Martial Arts styles for over 15 years and have always been curious about one particularly primitive part of my pugilist pastime: how hard I can punch?” Munro as…

The Bloomiere Casts Gentle Light, Or Blossoms Into Shade

Previous prototypes entered in the Pitch Your Prototype challenge have included an inexpensive medical device, educational kits and even an agricultural robot that plucks individual weeds out of the ground. A new entry, Bloomiere, takes the contest i…

Check Your Grill’s Remaining Propane? There’s An App For That

Ever wonder how many hours of grilling are left in a tank of propane? Makers Frank Vigilante and Brendan Glunz built a prototype device that can be attached to the standard brass valve between a propane tank and grill to measure the internal pressure

There’s Only A Month Left in the Pitch Your Prototype Challenge

There’s just over a month left to submit your own project to the Pitch Your Prototype challenge, a collaboration between Make: magazine and Cornell University with the goal of digging up promising prototypes from the Maker community. The individ…

LightUp Pitched Their Prototype. Now Their Device Is On The Market

In 2013, while they were enrolled at Shenzhen-based hardware accelerator HAXLR8R, Tarun Pondicherry and Josh Chan created a prototype of an educational electronics system they called LightUp. It was a crude mockup—Pondicherry recalls spray painting t…